Schedule 5S Pipe 16 Inch (DN400 mm) is a stainless steel pipe size commonly used in industrial piping systems where corrosion resistance and lighter wall thickness are required. This pipe size is typically referenced under ANSI/ASME B36.19, which is the standard used for stainless steel pipe dimensions.
For this size, the pipe has an outside diameter (OD) of 406.4 mm, an inside diameter (ID) of 398.02 mm, and a wall thickness of 4.19 mm. The listed pipe weight is 41.56 kg/m, while the weight including water is 165.91 kg/m.
Schedule 5S Pipe 16 Inch (DN400 mm) Dimension Table
| Pipe Size | NPS | DN | Outside Diameter (OD) | Inside Diameter (ID) | Wall Thickness | Weight |
|---|---|---|---|---|---|---|
| Schedule 5S Pipe | 16 Inch | DN400 | 406.4 mm | 398.02 mm | 4.19 mm | 41.56 kg/m |
What Is Schedule 5S Pipe?
Schedule 5S is a thin-wall stainless steel pipe schedule listed in ASME B36.19. The āSā designation is commonly used for stainless steel pipe schedules. Compared with heavier schedules, Schedule 5S provides a lighter wall thickness and lower pipe weight, which can help reduce handling effort, support load, and fabrication cost in suitable applications.
However, pipe schedule selection should always be reviewed against design pressure, temperature, corrosion allowance, project code, and service conditions before final use.
16 Inch Schedule 5S Pipe Data
- Standard: ANSI/ASME B36.19
- Pipe Type: Stainless Steel Pipe
- NPS: 16 Inch
- DN: DN400
- OD: 406.4 mm
- ID: 398.02 mm
- Wall Thickness: 4.19 mm
- Pipe Weight: 41.56 kg/m
- Weight Including Water: 165.91 kg/m
Common Uses of 16 Inch Schedule 5S Pipe
16 inch Schedule 5S stainless steel pipe may be used in applications where a large internal flow area and corrosion-resistant material are needed. Typical uses may include:
- Water treatment and utility piping systems
- Industrial stainless steel process lines
- Low-pressure transfer piping
- Food and beverage production systems
- Chemical and general fabrication projects
Why DN400 Pipe Dimensions Matter
Many users search for DN400 pipe dimensions to verify piping layout, support spacing, fabrication requirements, transport limits, and compatibility with fittings or connected equipment. For medium- to large-diameter piping, accurate dimensions are important for spool coordination, structural checks, and installation planning.
Knowing the correct 16 inch Schedule 5S pipe dimensions also helps engineers, designers, estimators, buyers, and students compare this size with other schedules when reviewing wall thickness, internal flow area, and total pipe weight.
NPS 16 and DN400 Explained
NPS stands for Nominal Pipe Size in inches, while DN stands for Diameter Nominal in metric designation. For this pipe size:
- NPS 16 = inch-based nominal pipe size
- DN400 = metric nominal designation
Although DN is shown in metric form, the actual outside diameter should always be checked from the dimensional standard. For this size, the OD is 406.4 mm.
Reference for Schedule 5S Pipe 16 Inch
This page provides a quick dimensional reference for engineers, piping designers, students, fabricators, and procurement teams looking for Schedule 5S Pipe 16 Inch (DN400 mm) data in a clear format.
Reference Standard: ANSI/ASME B36.19 stainless steel pipe dimensions.