Pipe Standards Made Simple

Tag: piping CAD

  • Concentric vs. Eccentric Pipe Reducers in CAD: Orientation, Flow, and Dimension Control

    Concentric vs. Eccentric Pipe Reducers in CAD: Orientation, Flow, and Dimension Control

  • Piping Specification Breaks in CAD: How to Locate and Document Material Class Boundaries

    Piping Specification Breaks in CAD: How to Locate and Document Material Class Boundaries

  • How to Read a Piping Line Number: Service, Size, Class, and Sequence

    How to Read a Piping Line Number: Service, Size, Class, and Sequence

  • Full-Port vs. Reduced-Port Valves: Bore Terminology, Selection, and CAD Documentation

    Full-Port vs. Reduced-Port Valves: Bore Terminology, Selection, and CAD Documentation

  • Piping BOM vs. MTO vs. Cut List: What Each Deliverable Controls

    Piping BOM vs. MTO vs. Cut List: What Each Deliverable Controls

  • Rolling Offsets in Piping CAD: True Offset, Travel, and Elbow Orientation

    Rolling Offsets in Piping CAD: True Offset, Travel, and Elbow Orientation

  • Spectacle Blinds, Spades, and Spacers in Piping CAD: Isolation, Status, and Joint Detailing

    Spectacle Blinds, Spades, and Spacers in Piping CAD: Isolation, Status, and Joint Detailing

  • Why Scaling a Piping CAD Block Does Not Create a New Pipe Size

    Why Scaling a Piping CAD Block Does Not Create a New Pipe Size

  • Pipe Inside Diameter and Flow Area: Why Nominal Size Is Not Enough

    Pipe Inside Diameter and Flow Area: Why Nominal Size Is Not Enough